Following the mixing instructions, make up a solution to the required strength and apply with a soft brush or car sponge. agitate lightly before rinsing with clean water. For heavier soiling, black streaks or tar spots etc: apply PAMPERVAN neat (straight from the tub) using a wet applicator, preferably hand - hot, leave for twenty minutes before rinsing off again. If necessary, leave to soak longer. PAMPERVAN will not scratch or damage soft acrylic windows or paintwork!

Using a spray bottle, (see mixing instructions) apply the solution lightly, be careful not to soak, to a small area at a time and leave for a few minutesbefore wiping off with a dry towel. For leather upholster, always do a test in a hidden area. Spray lightly and wipe off within 20 - 30 seconds. Do not allow the solution to dry on leather and always follow the manufacturers guide lines.

Add half a litre of boiling water to 1 table spoonful of PAMPERVAN and allow to cool. Apply the solution to the stain, allow to sit for 2 minutes and wipe off with a dry cloth. CHECK FOR COLOURFAST!

It will remove all stains except rust, permanent dye and paint. For heavier stains, apply PAMPERVAN neat with a wet cloth, rinse thoroughly and wipe dry with towelling fabric. Repeat if necessary. You may need to let the cleaner sit overnight; if so, leave a wet cloth on the area to keep moist. The longer the cleaner sits on the stain, the better the result.

For your stove, extractor fan, ovens and oven glass doors. Ceramic hobs and ranges (Rayburns and Agas) etc; use PAMPERVAN neta and apply to the soiled areas with a kitchen sponge using hand-hot water. For heavier or burnt on grease, PAMPERVAN may be left on for an hour or even overnight before rinsing off with clean water. You will find PAMPERVAN even more effective when applied to a warm oven or stove.

THERE ARE NO FUMES TO ENDANGER HEALTH

PAMPERVAN is great on stainless steel, granite and marble work surfaces. For light soiling on work-tops and kitchen cupboards, use a solution, spray on and wipe off again with a cloth or kitchen roll.

Using a bathroom Teflon sponge, apply PAMPERVAN neat to tiles & grout, shower trays, shower glass, shower doors / curtains, baths, sinks and fittings before rinsing off with clean water. When necessary, leave PAMPERVAN to soak for an hour or over night. For extremely bad areas, melt PAMPERVAN in amicrowave oven or a saucepan and apply hot with a scrub sponge. Let it sit for one hour before rinsing with clean water.

Spray the floors with the solution then wipe off with a damp mop. For rubber heel marks, apply neat. (full strength), let sit for 20 minutes then rinse.

Wash with a heavy solution or neat with a wet sponge.

Wet the area, apply PAMPERVAN neat and let sit for 1 hour. Use comb or fork to gently scratch the spot towards the centre. Rinse out with clean water.